How To Replace A Stock Window With Vinyl Siding

Each piece that is adjacent to the window should slide into the j channel but leave 1 4 inch within the j.

How to replace a stock window with vinyl siding. Once the new window has been put in place make sure that sufficient j channel molding has been installed so the siding can fit into place around the window. Extract nails keeping the vinyl pieces in place in order to prepare vinyl pieces to be removed. I would think that the best method would be to remove the whole window peel back the siding and replace it with the same size window with a nailing flange with either the built in channel or j it out. Use a siding removal tool.

Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes. Once it s been cut to size the siding is ready to be installed. Mark the siding at 1 4 inch past the edge of each. The easiest way to replace windows in a home with vinyl siding is to do the job from the interior.

The best way to get a replacement piece is to take the broken piece to vinyl siding distributors in your area and find the closest match. Step 1 measure the old window for dimensions for the replacement window using a tape measure. Write these measurements down on a piece of paper. Once the siding has been cut to fit allow inch for expansion it can be slid into the j channel with the bottom locked into place.

For more info on this topic visit my blog at w. Do not cut the vinyl off. Remove the pieces of vinyl siding from around the window area. In this video we ll show you the steps needed to replace a wood window in a house with siding exterior trim.

Subscribe to this old house. The current windows are builders grade new construction vinyl windows with the nailing flange and built in channel. Place the piece of siding to be installed under the window along the bottom edge and hold it where it will be located horizontally along the wall.