How To Install Vinyl Siding Last Row

To stiffen the trimmed section slide a length of utility trim.

How to install vinyl siding last row. Mark the length of vinyl where the cut needs to be made to achieve the correct fit. Measure and cut panel to fit. Install the tops first then the sides and then the bottoms of the window surrounds. Score the vinyl siding at the mark and break off the excess top by.

Vinyl siding installation is designed to hang loosely on the sheathing so that it can expand and contract with temperature changes. If the result is a whole number you re in. The siding slides behind vinyl siding trim pieces that hide the gap and the cut end. Install siding as normal until you reach the second row from the top.

Using a piece of scrap siding as a template measure the width of the second to last row marking it with your pencil. If you have to cut the last row of siding you ll. Use the wider starter strip. Use this template.

Finishing top row of siding under eaves. Measure the gap remaining at the top of the wall. Along the tops install j channel trim with horizontal siding and base trim with vertical siding. But if the result is not a whole number you will need to cut the final piece of siding lengthwise in order to fill in.

It protects the sheathing from rain snow and pests. Cut the trim so it is two channel widths longer than the opening s width. Then notch the next piece to fit. Measure and cut panel in the same manner detailed in step 14 but cut lower portion instead of top.

The bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. How do i put up a top piece of vinyl siding. Below the top of the foundation but the lower the vinyl siding is installed the better. Once it is in place test by sliding the last piece back and forth slightly.

To prevent the relatively thin panels from buckling observe these fitting and nailing rules. Drop siding panel into j channel around top of window and install. You must leave the bottom. Install j channels at doors and windows and under roof eaves and rakes.

Be sure to check both sides for proper fit. Push up gently until you hear a click. Push the top of the vinyl siding with the tabs into the utility trim just enough to hold the edge and push the bottom against the second to last piece of siding. Gap at all ends.

Divide the length of each wall by 8 inches the width of a piece of siding.