How To Install Drip Edge And Gutter

It should be a minimum extension of two inch from the fascia board on the roof.

How to install drip edge and gutter. Tools supplies tin sn. This is important to protect damage to your fascia soffits rafters. Please ensure that the drip edge is extended over the gutter. Installing drip edge on your roof.

The best practice is to always install the drip edge so that it is inside the gutter. Home centers sell rolls of 6 in. Secure the drip edge with roofing cement. The correct placement of the drip edge is the top of the roof directly between the shingles and the fascia board.

It can be done. With without rain gutters. The drip edge should be installed over a furring strip so that it tails off the fascia board. Begin at the lower corner of the roof and gradually progress to the top.

Use tin snips to cut the gutter apron flashing roll in two 3 in. If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter. Make sure the outer edge extends over the gutter. Make sure the corner is tight and that the bottom edge is tight to the fascia before nailing off the drip edge.

If it doesn t pull the drip edge out slightly from under the shingles. For proper water drainage the drip edge on the rakes should always overlap the drip edge on the eaves. Raise the shingles and push the top rim of your drip edge beneath them. But do not push it through the fascia.

Place a nail at one end then the other. Gently lift up the shingles on the edge of the roof and locate the nails holding the existing drip edge onto. Once free slide the drip edge out and discard. How to install a drip edge.

The whole purpose is to direct the water into the gutters. Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated. Slide the corner tight to the fascia. You may need to nail through the starter strip into the drip edge.

If your gutter has been previously installed rather than taking it down and redoing it you can easily place a small strip of metal flashing under the drip edge and over the back of the gutter as shown by the illustration at the bottom of this page so the water will shed into the gutter.