How To Fit Roofing Felt To Shed

You should nail the felt in a regular pattern.

How to fit roofing felt to shed. Unroll your felt onto a flat surface. Start at the bottom of the roofline and work up so any water that gets through the roofing material will shed down the tar paper and will not go under it. 1 for each side of the roof as well as a third section that will overlap the 2 side panels by about 30cm on each side and run along the top ridge of the shed. Lightly scratch a vertical line on the surface with the rear of the blade to mark the length of your shed plus the front and rear overlaps.

Cut the felt to size using a hooked blade knife. Most people prefer to set the nails with 12 inch centers along the bottom edge and then 30 to 36 inch centers along the top. Unroll the paper about five feet along the edge of the roof. Tack the felt paper in the center to hold it in place.

Move the ladder down the side of the shed. For most sheds you ll need to cut 3 pieces of felt. Begin installing the roofing felt at the edge of the eave. You ll need enough felt to cover the entire area of the roof with a little extra on each edge around 5cm to allow for overlaps at the eaves and at the gable ends approximately 7 5cm.

Step by step guide on how to apply bituminous roofing felt to your shed roof. Also make sure you are driving each nail flush. Laying the felt the roofing felt should be applied in layers that overlap. Measure the roof of your shed.

As you work the paper can be tacked down in the center so it won t blow away. Mark the same at the other end of the roll.