How To Felt Paper A Roof

A third layer of felt needs to be placed.

How to felt paper a roof. Begin your first row of tar paper with the bottom of the tar paper slightly hanging over the edge of the roof. Tack it in place at the corner with the end flush with the end of the roof and the bottom edge of the roll right along the bottom of the roof. Use a ladder to reach the bottom level of the roof. Roofing felt is sold in rolls and the product label will give information on the area contained.

Tack the felt onto the initial rolling spot using a tack gun. There needs to be an overlap in the felt to help increase the water tight quality. Step 2 roll it out. You will be placing the second layer of felt over this.

Clean the decking as well as. Attaching your roof felt 1. An assumption is made all materials are ordered based on the necessary measured requirements. Position the first row of roofing felt flush on the bottom with the edge of the gutter apron.

Pry away the siding and slip the felt under the siding. Roll out the tar paper along the. Start rolling the first layer of felt out from the bottom of one side of the roof. Roofing felt comes in rolls that feature.

Start at the bottom of one side of the roof at the right or left edge. Divide the area of your roof by the area of the felt rolls you plan to use and allow an approximate 10 extra for waste. Step 3 overhang paper. How to install roofing paper.

Step 1 prep the area. How to lay roofing felt on a hip roof step 1. Start at the bottom of the roofline and work up so any water that gets through the roofing material will shed down the tar paper and will not go under it. The roofing felt should be applied in layers that overlap.

As you work the paper can be tacked down in the center so it won t blow away. You wan walk over the roof to remove any air bubbles that may form. In some situations you may have to temporarily remove the siding and replace it after installing the underlayment shingles and flashing. Begin at the bottom right or.

Attach where roof meets wall where the roof meets a wall lap the felt up 4 inches if possible. Step 4 over the peak. Return to the side that you began rolling from and. Paint a thin layer of adhesive over the first felt layer.

Continue pulling the felt tight.